Canon PIXMA MP160 All-In-One InkJet Printer How to reset the ink level monitor on Canon Prixma..

Problem

After the ink cartridge for the Canon Prixma MP 160 have been refilled and test then I press the button Stop / Reset several times but unfortunately the problem low ink indicator is still remaining as before although I have done as some user online suggested. Please tell me what to do the correct steps to resolve this issue

Solution

1. may the error code or how many blinking can solve your problem
   
   this is the list of error code
   
   How to clear Error Code Canon printers MP150 MP160
   CANNON Printers MP150/MP160 ERROR CODE
   
   E2-2 No paper (ASF)
   E3-3 Paper jam
   E4 No ink
   E5-5 The ink cartridges are not installed or a non-supported ink cartridge is installed ,
   or the ink cartridges are not installed properly
   E8 Waste ink absorber full, or platen waste ink absorber full
   
   E9 The connected digital camera / video camera does not support Camera
   Direct Printing
   E14 The Ink cartridges whose destination are wrong
   E15 Ink cartridge is not installed E16 - Ink remaining is unknown
   E16 -E19 Failed to scan head alignment sheet
   E22 Carriage error
   E23 Paper feed error
   E24 Purge unit error
   E25 ASF(cam) sensor error
   E26 Internal temperature rise error
   E27 Waste ink absorber full or platen waste ink absorber full
   E28 Ink cartridge temperature rise error -
   E29 EEPROM error
   E33 Paper feed position error
   E35 15 USB Host VBUD overcurrent error - USB
   E37 17 Abnormal motor driver error
   E40 20 Other hardware error
   E42 22 Scanner error
   
   
   
   
   try this methode
   
   Methode 1
   
   1) With the printer powered off but connected to a power source, press the Power button while pressing and holding
   the Stop/ Reset button.
   2) When the Power LED is lit, press the Stop/Reset button two times while pressing and holding the Power button.
   3) When releasing the Power button and the Stop / Reset button (regardless of order), the printer will move into a
   service mode. (Waiting formenu selection)
   4) When the LED lights in green, press the Stop/Reset button the specified number of time(s) according to the
   function listed in the table below.(Each time the Stop/Reset button is pressed, the LED lights alternately in
   orange and green, starting with orange.)
   The number of the Reset
   button pressing
   LED Function Remarks
   
   0 time Green Power off
   1 time Orange Service pattern print
   2 times Green EEPROM print
   3 times Orange EEPROM reset
   4 times Green Waste ink counter reset See waste ink counter reset
   procedures below.
   5 times Orange Destination setting See Destination setting
   procedures below.
   6 times Green Print head deep cleaning
   11 times Orange Button / LCD checking
   12 or more times Returns to a menu selection